EspañaBanderaIcono

1

IMAGEN

2

IMAGEN

3

IMAGEN

4

IMAGEN

5

IMAGEN

6

IMAGEN

 

 

Micro Gimbal is easy to assemble. It support gopro accessories, although certain aspects should be taken into account so that the image is as clean as possible.

The main thing is the site where it will anchor the equipment should be an area as rigid as possible.

In the case of motorcycles, if you are going to anchor in the deposit or fairing, these must be secured. Any vibration that have these elements are inevitably transmitted to the camera mount and the image will also vibration.

Micro Gimbal is compatible with most GoPro accessories market. But you must have in mind that these accessories, especially the plastic, are designed to withstand the weight and inertia of the case GoPro. That is why when we ride our support almost tripled the weight camera/case, and therefore cannot do their function properly.

To solve this problem, we included in the support arm designed to withstand the weight, this has been successfully tested by our betatester. We recommend mounting this arm in all situations, except chest harness assembly. Harness, assembly need not arm.

Micro Gimbal team is not responsible to solve the vibration of the image, because they depend very much on the state of the area which is to be mounted.

go1 go2 go3 go4 go5 go6 go7 go8

[fruitful_btn]Manual English Mg“[/fruitful_btn]